Build Your Own Electricity
It has been a historical analysis that billions of years back and up to this time, the sun has a remarkable impact towards the lifestyle of every man. Many people have concluded that not only in the past by which sun’s energy has been a necessity but as we keep going, this will remain a part of one’s everyday life.
With the growth of Science and modern technology, there have been numerous inventions that flourished. One of the most distinguished advancement was the creation of the Solar cells. With this latest perception of energy transformation from the sun, many people were determined and have become attracted of knowing the techniques towards making this homemade solar cells.
To design a great and exceptional homemade solar cells, it is advisable to get ready with all the required tools that you may be needing just like the pre-wired Solar Series, particle board, Masionite panel, UV Shield, Screws, Plexiglas, Caulk and drill bit.
Learning the basic information about the procedures or by simply watching the steps on the net will surely lead you to a fast and easy means of finishing your homemade solar cells. You have to remember though, that your endeavor will bring about a good and favorable solar panel if only you set your time and dedication in it.
The 1st activity to make is to come up with a box with the ideal specifications for all your cells to be accommodated. Cover the box with three coatings of Ultra Violet Protection and be sure that it is not impacted by the sun’s Ultra violet rays. This is so because it is the place you will set up your pre-wired solar cells. Then bore holes at the reverse area of the solar panel container so that thermal heat can pass through it and therefore, controlling the wood from perverting . In the wooden box, a layer of Masonite peg-board coated with UV Guard must be put inside so that there is something in which to attach the solar panels.
When the solar panels are firmly attached to peg-board, it is required to be contained in the solar panel box. After the cabling has been accomplished, you will need to cut the Plexiglas and put it just on top of the box and fasten it. Now at last, you have already engineered your own solar panel now.
